LED Running Lights Turn Signal Kit
This is a 12 volt LED Running Lights Turn Signal Kit with Super Bright D.O.T. approved LED lights (no brackets required). Our LED running lights turn signal kit comes with 2 surface mounted ¾” inch amber (front) dual mode lights. In addition, 2 surface mounted ¾” inch red (rear) LED dual mode lights. However, you can add additional lights to give your street legal UTV a custom look.
Why Our Turn Signal Kits are Completely Independent
I get asked a few times every month, why don’t you use the UTV or ATV rear OEM lights for the rear turn signals? The answer is very simple. I developed my Turn Signal Kits (TSK) to be completely independent for THREE main reasons. ONE, you do not want any possible feedback from the LED Electronic Flasher into the ECU of your UTV or ATV. Consequently, electronic feedback can cause problems with your ECU and they are very expensive to replace. TWO, you do not want to affect (invalidate) your manufactures warranty by tapping into any existing OEM lights or wiring. THREE, you want both rear stop lights when activating the turn signals (like our automobiles), not just one. As a result, with all my different turn signal kits you will never have these concerns or issues.
LED Running Lights Turn Signal Kit Specifications
This LED running lights turn signal kit comes with a turn signal switch. First of all, it has a pilot light for the turn signals and 4-way emergency flashers (hazard warning). Secondly, the turn signal switch has a pull out flare tab for the 4-way hazard lights. Finally, it comes with the hardware to mount it to your steering column.
The four LED Dual Mode Super Bright Lights are ¾” inch round with an attached rubber grommet for quick mounting. Secondly, they are surface mounted LED’s with a slim-line design for mounting in small spaces (no brackets required). Furthermore, they have 3 lead wires each, one for ground, one for normal mode (running) and one for high mode (signals). In addition, they meet the P2PC requirements for 45 degree mounting and provide superior light output. Furthermore, they have a Space Saving Design, Hi Impact Acrylic Lens and Housing. Finally, they have Completely Resin Sealed Electronics to eliminate corrosion.
This special LED Flasher has the 3 pin connections for LOAD, PILOT and POWER. Also, the electronic LED flasher is quite, no annoying clicking sounds.
The Running Light Switch is a LED waterproof illuminated rocker switch. Above all it is easy to install, vibration resistance, and will illuminate when activated.
LED Running Lights Turn Signal Kit
Our LED Running Lights Turn Signal Kit includes. 2 Amber and 2 Red SM LED Dual Mode super bright lights with grommets. Secondly, the turn signal switch with hardware to mount it to your steering column (see TSS mounting hardware). Also, a waterproof LED rocker switch and special LED Flasher with mounting hardware. Furthermore, an ATC in-line fuse holder with a 3 amp fuse. In addition, the mounting installation instructions with wiring instructions & diagram. Most importantly, with our LED Running Lights Turn Signal Kit you get all the help & support you need from EZ Turn Signal Kits.
LED Running Lights Turn Signal Kit Important Note
Note FYI: I have heard people say that a column mounted Turn Signal Switch (TSS) is in the way of you entering and exiting the unit, not true! Secondly, they say you will bump the TSS lever with your legs and even break that lever, again not true! In other words, I am 6’3″ and 250 pounds, I have never bumped the TSS and I use my units multiple times a day. Finally, I have sold thousands of the column mounted TSS and never had a customer complain about bumping or breaking one.
LED Running Lights Turn Signal Kit Installation
This kit can be easily installed, it does not go into any factory wiring and above all it will not void your manufactures warranty! In addition, each wire has a different color and the wiring diagram shows where each colored wire goes. Above all, I include my phone number and e-mail address with the instructions. Therefore, if you have any questions about your installation you can contact me.
This turn signal switch has been installed on thousands of units, very nice and easy to operate. The Motor Vehicle Department and your local police departments will be impressed. Most noteworthy, everyone who rides on the street or off road (dunes/congested areas), should have turn signals for their added safety.
The LED Running Lights Turn Signal Kit will fit most of the UTV models (check the TSS mounting hardware).
In addition you can customize the UTV with Double or Triple lights. As a result, order from the drop down box Light Options: Double Lights: 4 Amber & 4 Red lights or Triple Lights: 6 Amber & 6 Red lights.
LED Running Lights Turn Signal Kit Options
Options: We have some additional LED Lights and Custom TSS Mounting Hardware. In addition, a UTV Wire & Connector Kit and LED Dash Indicator lights. Therefore, you may want to use these with your LED Running Lights Turn Signal Kit. That is to say, any of these options purchased with your LED running lights turn signal kit, will save you time & money!
Option1 – Double or Triple Lights for a custom look!
Option2 – Turn Signal Switch (TSS) mounting hardware for your particular year, make and model.
Option3 – UTV Wire and Connector Kit, this kit will make it easy to connect your turn signals.
Option4 – Dash Indicators for those that want one or two dash indicators.
You can order whatever options you want with your Turn Signal Kit by using the drop down (∇) menus above.
Copyright © 2009-2021
Looking for a SM LED Turn Signal Kit checkout our SM LED TSK #104.
Have you seen the new Polaris models?